Q7 STARTER KIT 2.1

LVDS Single/Dual Channel 18-24-bit + HDMI Connector or 2 x
eDP connectors + Multimode Display Port

1x SATA connector with HDD power connector
1x M.2 Socket 2 2242 Key B SSD slot
microSD Slot on combo microSD + SIM connector

2 x Gigabit Ethernet connectors
1 x M.2 Socket 2 2242/3042 Key B Slot for WWAN cellular
modem modules, connected to on-board miniSIM slot

2x Superspeed USB 5Gbp Host port on dual Type-A socket
1x USB 2.0 Host ports on double Type-A sockets
1x USB 2.0 Host on internal M.2 socket
1 x USB 2.0 OTG port on micro-AB socket (USB port shared
with USB 2.0 lanes of 1 x USB 3.0)

Audio interface on internal pin header

4-wires RS-232 / RS-422 / RS-485 configurable serial port on
DB9 male connector
2x RS-232 full-modem serial ports on internal header (need
LPC interface from Qseven® module)
CAN interface on PCB terminal block

SPI internal pin header
LPC Bus internal pin header
16x GPIO signals on pin header via a GPIO expander
controlled via SM Bus or I2C
Front panel header
1x 28 pin connector for additional features (I2C, ACPI signals,
SMBus, watchdog, thermal management)
+12V tachometric FAN connector
Optional debug USB port on miniB socket
Optional MFG connector for JTAG programming of Qseven®
module

24VDC ±5% through Micro-fit 2x2 power connector
Coin cell battery holder for powering CMOS and RTC

-40°C ÷ +85°C (Industrial temperature range)

*All carrier board components must remain within the operating temperature at
any and all times, including start-up; carrier operating temperature is independent
of the module installed. Please refer to the specific module for more details. Actual
temperature will widely depend on application, enclosure and/or environment. The
customer must design a product-specific cooling solution for their final system.